IceCap ATO EZ Automatic Top-off System

IceCap ATO EZ Automatic Top-off SystemWater Pump SpecificationsBrushless DC Water Pump (30000hrs)Dimensions: 1.5 x 1.5 x 1.5inMaximum Head: ~6ftFlow Rate: 50gphPower: 5wTubing Size: ID 6.5mm/OD 8mm/6ftThe IceCap ATO EZ is a reliable triple optical sensor Auto Top Off management system that monitors and automates refilling evaporated water. Includes everything needed to install and operate.Replenish Evaporated Water… with Confidence!The IceCap ATO EZ System is an easy-to-use pump and sensor combo that offers peace of mind when replenishing evaporated water to an aquarium. Its twin optical sensors extend the devices life and reliability by limiting the frequent powering on and off of the refill pump. This system also includes a third (safety) sensor that provides another level of security to prevent overflows.The IceCap ATO EZ is a well-thought-out automated system with a fail-safe design that uses two (2) optical sensors to monitor the fluid level of your aquarium or sump. The third optical sensor provides real-time protection against the failure of the second sensor. Best of all, it is very easy to install and contains no moving parts that can fail.Complete Auto Water Top-off System for Fresh and Marine AquariumsEverything is provided for installation and operation.You simply move the magnet optical sensor to the desired water level within your sump or aquarium.Its that easy!ATO EZ OperationWhen the water level in the sump or aquarium drops below theLOW LEVEL (3)on the sensor, it will blink blue until the water level rises to theNORMAL LEVEL (2).When the NORMAL water level resumes, a solid blue light will display.SAFETY LEVEL SENSOR (1)is a backup to shut down the feed pump in case of a malfunction; in this case, a red light will flash.STEP 1- Mount the SensorInstall the sensor with the cord directed upwards into the aquarium or in the last chamber of the sump. Next, move the sensor so the desired water level sits between the second and third inner sensors. Mounts to clear, tinted, or painted surfaces up to 1/2in thick.STEP 2- Install Refill PumpAttach the hose to the output of the fill pump and place it upright into the reservoir. Run the hose vertically to the sump or aquarium without kinks. Do not exceed 6ft total length. Plug the end of the pump chord into the port labeled PUMP on the sensor connection.STEP 3- Connect to PowerAttach the power connection to the POWER port located on the sensor connection. Then attach the power adapter to a standard AC wall outlet. The installation of the IceCap ATO EZ is complete.